5 Simple Steps Guide to Install Metal Studs

Whether you are looking for construction options for your office or a commercial project, the inclusion of metal studs is highly essential. That is because it is not only cheap but a very feasible replacement for wood since it will not have qualities to create mold.

The metal stud installation cost is quite reasonable as well. Starting from $2 for a range of one square feet, wood should never be considered as an option because of its lack of affordability. Here are some steps to follow if you want to install quality metal studs.

1-) Make use of the Correct Toolset:

Since you will have to hang the studs to the tracks, a number of tools will be required in doing so. Some of the best tools for metal stud installation can be found online but here is the list of the toolset you would require.

  • Metal saw
  • Drill machine
  • Box of chalks
  • Clamp set
  • Level for plumbing

Once you have the equipment, carry on to the second phase.

2-) Accumulate the Total Number of Studs Required:

If you fail to count the total number of studs, you might end up falling short and it will create more issues for you. The typical size of a stud required for a wall is 12 inches in a linear wall. Make sure you measure the space correctly and not leave out any gaps. It is better to always keep extra studs with you as well.

3-) Time to Plumb the Tracks:

Once all the tools and studs have been gathered, time to plumb the tracks. You will have to begin with the lower and upper tracks initially. The toolset will come in handy with the fastener and laser bob for plumbing. Using one requires for you to keep the laser vertical alongside the wall. That makes the process quicker and more efficient.

After that, you have to place a plumb bob. The plumb then is attached on to the wall and is faced downwards. However, ensure both the levels are symmetrical and are kept unhindered. If not, the installation process will become shaky.

4-) Ensure the Metal Studs are Fastened Accurately:

In order to fasten the studs you have just installed, the length of the studs should be trimmed down to an extent. Use a scissor to hold down the snips and cut the excess stud coming out from the sides. This is all done so manually but the next phase is of an electrical installation. This is a bit tricky and risk so as a precaution, you should be wearing safety gloves beforehand.

Cut several pieces of the excess metal stud and use a knife to hold down the stud parts to break it down further. The electrical cable should be then passed right out of each stud. However, the cable should not touch any sharp areas or else it will not function correctly.

5-) Some Finishing Touches to Add:

After you have carefully followed all the steps compiled so far, a few finishing touches would be required. Since the metal studs have high risk of rotting and other similar issues, you should ultimately hang them across a dry wall so that no such problems are faced in the long run.

Leave a Reply

Your email address will not be published. Required fields are marked *